Correction for the window slap issue in the 2020 Model Y passenger door?

[silver6933]

Purchased a pre-owned 2020 model around six months ago, and it is the most advantageous $17,000 I have ever invested! It even included Full Self-Driving!

The only concern is that the passenger door window strikes the frame during closure. There is no wind noise when driving, indicating a secure fit on the frame; nonetheless, it rattles significantly while closing the door.

The technician at my nearby Tesla service center said that the issue is typical due to the frameless design of the doors; nevertheless, he did not recognize the severity of the problem in comparison to the driver's side door. It is quite evident.

My investigation indicated that early Model 3s may modify the window angle by removing the door panel; however, Y doors are constructed differently.

Is there a method to do a DIY repair on a window slap?

[PeonySilver]

Commence by recalibrating the window action.

 

[PeonySilver]

https://service.tesla.com/docs/Public/diy/modely/en_us/GUID-B6C81FC2-A37C-462B-8A71-FDE0F7B0734E.html

[silver6933]

The calibration yields identical findings.

[ultimatesoy]

The window should descend with the opening of the door. This prevents contact with the trim.

[silver6933]

Indeed, when opening the door, the window descends slightly to avoid obstructing the trim. I am referring to the situation when the door is closed. The slow-motion footage shows it rebounding off the trim before coming to rest.

[ultimatesoy]

To the best of my knowledge, it should not be elevated till it surpasses the trim. I contend that my mine ascends upon contact with the gasket, far from the trim.

[MokweleScoop]

A malfunctioning door latch may be indicated if the window operates prior to the door being completely closed.

[silver6933]

I must clarify that the glass is making contact with the window's gasket when it is closed, not the trim. It ultimately comes to rest at a considerable distance after completing its bounce. I will attempt to upload a video later.

[silver6933]

I found it amusing how similar our names are.

[shakee]

If you have previously calibrated, remove the door seal and carefully reattach it. Occasionally, they are not positioned properly.

[teara23]

I was taken aback upon reading the original post.